Table of Contents
Advertisement
Installation
Ê Place the spring nuts to fasten the telescopic rails in the groove of the
support uprights at the marked attachment points.
Ê If necessary, adjust the position of the nuts in the groove until they lock into
the correct position.
To fasten the left telescopic rail to the support bracket, no flange nuts are
necessary since the assembly bracket (HL) is equipped with threaded holes.
For adjustment two mounting springs must be pre-installed in the support
bracket (see figure 8 on page 29):
Figure 8: Mounting the springs in the support bracket
Ê Place the mounting springs (1) at the marked attachment points in the corre-
sponding holes of the support bracket.
U41271-J-Z156-2-76
Installing the Rack Model in the Rack
29
Advertisement
Table of Contents
