Irc-6 Infrared Remote Control; Irc-6 Operation - Chauvet DJ 4BAR Flex Q User Manual

O
PERATION

IRC-6 Infrared Remote Control

The 4BAR Flex Q is compatible with the IRC-6 infrared remote control from Chauvet. To activate IR mode,
follow the instructions below:
1. Press <MENU> repeatedly until Set shows on the display.
2. Press <ENTER> to accept.
3. Press <UP> or <DOWN> to select On or OFF.
4. Press <ENTER>.

IRC-6 Operation

Automatic Mode
Automatic mode will enable you to run the automatic programs on the product.
To turn on Automatic mode:
To adjust the speed of the automatic program:
Sound-Active Mode
Sound-Active mode will enable the product to respond to the music.
To turn on Sound-Active mode:
To adjust sound sensitivity in Sound-Active mode:
Manual Color Control
To choose a specific color with the IRC-6:
To manually control the RGB percentage:
Miscellaneous Operations
To adjust the total output level:
To adjust the strobe rate of the program:
To select only fading programs:
To black out the lights:
This will turn off all the lights until the button is pressed again.
The IRC-6 will not respond to any inputs when Black Out is activated. If the remote
does not respond when a button is pressed, try pressing <BLACK OUT>. You may
have inadvertently activated Black Out.
4BAR Flex Q User Manual Rev. 1
1. Press <AUTO> on the IRC-6.
2. Press <+> or <–> to choose between the different auto programs.
1. Press <SPEED> on the IRC-6.
2. Press <+> or <–> to increase or decrease the speed of the program.
1. Press <SOUND> on the IRC-6.
2. Press <+> or <–> to select a sound-active program.
1. Press <SENSITIVITY> on the IRC-6.
2. Press <+> or <–> to increase or decrease the sound sensitivity.
1. Press <MANUAL> on the IRC-6.
2. Press any number between 0–9 to choose your color.
1. Press <MANUAL> on the IRC-6.
2. Press <R> (red), <G> (green), or <B> (blue) to choose your color.
3. Press <+> or <–> to increase or decrease the value of each color.
4. Repeat steps 2 and 3 until desired output is achieved.
1. Press <%> on the IRC-6.
2. Press <+> or <–> to increase or decrease the output level.
1. Press <STROBE> on the IRC-6.
2. Press <+> or <–> to increase or decrease the strobe rate.
3. Press <STROBE> again to turn off the strobe.
• Press <FADE> on the IRC-6.
• Press <BLACK OUT> on the IRC-6.
Page 14 of 19