Irc-6 Infrared Remote Control; Irc-6 Operation - Chauvet DJ EZLink Par Q4BT User Manual

IRC-6 Infrared Remote Control

The EZLink Par Q4BT is compatible with the IRC-6 infrared remote control from Chauvet. To activate IR
mode, follow the instructions below:
1. Press <MENU> repeatedly until SEt shows on the display.
2. Press <ENTER>.
3. Use <UP> or <DOWN> to select ir.
4. Press <ENTER>.
5. Use <UP> or <DOWN> to select on.
6. Press <ENTER>.

IRC-6 Operation

Automatic Mode
Automatic mode will enable you to run the automatic programs on the product.
To turn on Automatic mode (snap) with the IRC-6:
BLACK
AUTO SOUND
OUT
SENSI-
STROBE SPEED
TIVITY
To select only fading programs:
%
MANUAL
FADE
R G B
To adjust the speed of the automatic program:
A UV W
-
+
0
Sound-Active Mode
1 2 3
To turn on Sound-Active mode with the IRC-6:
4 5 6
7 8 9
To adjust the sound sensitivity:
Manual Color Control
To select a preset static color with the IRC-6:
To manually control the RGB percentage with the IRC-6:
Strobe
To adjust the strobe rate with the IRC-6:
Dimmer
To adjust the total output with the IRC-6:
Black Out
To black out the lights with the IRC-6:
This will turn off all the lights until the button is pressed again.
The IRC-6 will not respond to any inputs when Black Out is activated. If
the remote does not respond when a button is pressed, try pressing
<BLACK OUT>. You may have inadvertently activated Black Out.
Page 10 of 15
1. Press <AUTO> on the IRC-6.
2. Press <+> or <–> to choose between the different auto programs.
1. Press <FADE> on the IRC-6.
2. Press <+> or <–> to choose between the different fading programs.
1. Press <SPEED> on the IRC-6.
2. Press <+> or <–> to increase or decrease the speed of the program.
1. Press <SOUND> on the IRC-6.
2. Press <+> or <–> to select a sound-active program.
1. Press <SENSITIVITY> on the IRC-6.
2. Press <+> or <–> to increase or decrease the sensitivity.
1. Press <MANUAL> on the IRC-6.
2. Press any number between 0–9 to choose your color.
1. Press <MANUAL> on the IRC-6.
2. Select the color to be edited, from <R> (red), <G> (green),<B> (blue), or
<A> (amber).
3. Press <+> or <–> to increase or decrease the value of the selected color.
4. Repeat steps 2 and 3 until the product outputs as desired.
1. Press <STROBE> on the IRC-6.
2. Press <+> or <–> to increase or decrease the strobe rate.
3. Press <STROBE> again to turn off the strobe.
1. Press <%> on the IRC-6.
2. Press <+> or <–> to increase or decrease the output level.
1. Press <BLACK OUT> on the IRC-6.
EZLink Par Q4BT User Manual Rev. 7
Operation