Factory Reset; System Information; Irc-6 Infrared Remote Control; Irc-6 Operation - Chauvet DJ INTIMIDATOR SCAN 360 User Manual

Factory Reset

To restore the Intimidator Scan 360 to factory default settings, follow the instructions below:
1. Press <MENU> repeatedly until Setup shows on the display.
2. Press <ENTER>.
3. Select Reset to revert the fixture to its default factory settings.
4. Press <ENTER>.

System Information

To view the system information on the Intimidator Scan 360, do the following:
1. Press <MENU>.
2. Use <UP> or <DOWN> to select Sys Info.
3. Press <ENTER>.
4. Select Ver (displays the fixture's software version), Running Mode (displays the current running
mode), DMX Address (displays the current DMX mode), and Temperature (displays the fixture's
current temperature in Celsius).

IRC-6 Infrared Remote Control

The Intimidator Scan 360 is compatible with the IRC-6 infrared remote control from Chauvet. To set the
Intimidator Scan 360 to IR mode, follow the instructions below:
1. Press <MENU> repeatedly until Run Mode shows on the display.
2. Press <ENTER>.
3. Press <UP> or <DOWN> to select IR.
4. Press <ENTER>.

IRC-6 Operation

Automatic Mode
Automatic mode will enable the user to run the automatic programs on the product.
To turn on Automatic mode:
BLACK
AUTO SOUND
OUT
To adjust the speed of the automatic program:
SENSI-
STROBE SPEED
TIVITY
%
MANUAL FADE
R G B
Sound-Active Mode
Sound-Active mode will enable the product to respond to the music.
A UV W
To turn on Sound-Active mode:
-
+
0
Sound Sensitivity
1 2 3
4 5 6
7 8 9
To set all LEDs to full intensity:
Miscellaneous Operation
To adjust the output level of the LEDs in manual color mode:
To black out the lights:
This will turn off all the lights until the button is pressed again.
NOTE: The IRC-6 will not respond to any inputs when Black Out is activated. If the
remote does not respond when a button is pressed, try pressing <BLACK OUT>.
Black Out might inadvertently been activated.
12
• Press <AUTO> on the IRC-6.
1. Press <SPEED> on the IRC-6.
2. Press <+> or <–> to increase or decrease the speed of the program.
• Press <SOUND> on the IRC-6.
• To adjust the fixture's sensitivity to sound:
1. Press <SENSITIVITY> on the IRC-6.
2. Press <+> or <–> to increase or decrease the sound sensitivity.
• Press <0> on the IRC-6.
• Press <%> repeatedly on the IRC-6.
• Press <BLACK OUT> on the IRC-6.
Intimidator Scan 360 User Manual Rev. 3
Operation