Master/Slave Mode; Master/Slave Mode (Wired); Master/Slave Mode (D-Fi Usb) - Chauvet DJ 4BAR Flex Q User Manual

Master/Slave Mode

The Master/Slave mode allows a single 4BAR Flex Q product (the "master") to control the actions of one or
more 4BAR Flex Q products (the "slaves") without the need of a DMX controller. The master product will
be set to operate in either standalone mode or with the footswitch, whereas the slave products will be set
to operate in slave mode. Once set and connected, the slave products will operate in unison with the
master product.

Master/Slave Mode (Wired)

Configure the products as indicated below:
Slave products:
1. Press <MENU> repeatedly until 4Ch, 6Ch, or 19Ch shows on the display.
2. Press <ENTER> to accept.
3. Set the DMX address to d.1.
4. Connect the DMX input of the first slave product to the DMX output of the master product.
5. Connect the DMX input of the subsequent slave products to the DMX output of the previous slave
product.
6. Finish setting and connecting all the slave products.
Master product:
1. Set the master product to operate in Automatic or Sound-Active mode.
2. Make the master product the first product in the DMX daisy chain.
• Configure all the slave products before connecting the master to the daisy chain.
• Never connect a DMX controller to a DMX string configured for Master/Slave
operation because the controller may interfere with the signals from the master.

Master/Slave Mode (D-Fi USB)

The D-Fi USB allows a single 4BAR Flex Q product (the "master") to control the actions of one or more
4BAR Flex Q products (the slaves) without the need of a DMX controller or DMX cables. The master
(transmitter) product will be set to operate in either standalone mode or with the footswitch, whereas the
slave (receiver) products will be set to operate in slave mode. Once set and connected, the slave products
will operate in unison with the master product. Configure the products as indicated below:
Slave products:
1. Press <MENU> repeatedly until 4Ch, 6Ch, or 19Ch shows on the display.
2. Press <ENTER> to accept.
3. Set the DMX address to d.1.
4. Set D-Fi USB to receive on a specific channel, 1–16.
5. Plug in the D-Fi USB.
6. Finish setting and configuring all the slave products.
Master product:
1. Press <MENU> repeatedly until the DMX personality the slaves are set to shows on the display.
2. Press <ENTER> to accept.
3. Set the DMX address to d-1.
4. Set the master to operate in either Automatic or Sound-Active mode.
5. Set the D-Fi USB to transmit on the D-Fi channel the slaves are receiving on.
6. Plug in the D-Fi USB.
• All products must be set to the same DMX personality, DMX address, and D-Fi
channel.
• Configure all the slave products before configuring the master to transmit.
• Never connect a DMX controller to a D-Fi channel configured for Master/Slave
operation because the controller may interfere with the signals from the master.
Page 15 of 19
O
PERATION
4BAR Flex Q User Manual Rev. 1