Table of Contents
Advertisement
4.4.3 Snapshot Tab
The Snapshot tabbed pane sets the Camera to take snapshot images when event
is triggered. The four methods available for selection are Always, Schedule,
Motion, and GPIO Input, each of which can be set up with user scheduled time
and capture interval, as well as defining the snapshot file target destination.
Always:
iCAM-760D User's Manual
Under this method, the Camera automatically continuous to capture
snapshots of the area under surveillance at every 1, 2 or 3 seconds
interval. The stream of accumulated snapshots may be stored in the
SD Card, Remote Disk, sent to host by E-mail, FTP as preferred or
through all of them.
ICP DAS
Snapshot is triggered at every
1, 2 or 3 seconds interval.
Chapter 4
Setup 77
Advertisement
Table of Contents
