GPIO Input:
The stream of accumulated snapshots stored in the SD Card, Remote Disk, sent
to host by E-mail、FTP, activated GPIO Output Port as preferred or through all
of them. When E-mail/FTP target is selected, the illustration of these methods
setup dialog will display in the following figure.
iCAM-760D User's Manual
This method will trigger the Camera snapshot operation
according to the set time interval (in seconds) whenever GPIO Input
Signal is detected within the defined days of the week and at the time
of the set days.
(As for the more GPIO Signal Settings, you may refer to
Tab)
ICP DAS
Chapter 4
4.4.4 GPIO
Setup 80