Warranty - Technogel Mixpasto 60 Use And Maintenance Instructions

Each chapter has a right page that recalls the number and title of the chapter.
A chapter, for example chapter 1, contains:
1 Heading of the chapter
1.1 Title of the paragraph
1.1.1 Heading of the subtitle
1.1.1.1 Any additional subtitle
The numbering of the figures and tables is reset at every chapter, therefore the progressive prefix indicating
the chapter and the number of the figure or table restarts from 1 at the beginning of each chapter.
1.2.2 Description of pictograms
The following symbols are used in the manual to highlight particularly significant indications and warnings:
ATTENTION:
This symbol shows accident-prevention standards for the operator and/or for any exposed people.
WARNING:
This symbol shows the existence of the possibility of damaging the machine and/or its components.
NOTE: This symbol provides useful information.
1.3

WARRANTY

The TECHNOGEL SpA manufactured machines are covered by WARRANTY, as provided by the general
selling conditions. In the event that defective or faulty machines parts are found during the validity period,
and when these parts are covered by the warranty, TECNOGEL SpA will repair or replace the part only after
having checked it with the distributor from whom the machine was purchased.
TECHNOGEL SpA considers itself responsible for the machine in its original configuration.
All interventions modifying the structure and functioning cycle of the machine must be expressly authorised
by TECHNOGEL SpA only.
All technical modifications affecting the functioning or safety of the machine must only be carried out by the
manufacturer's technical personnel or by its officially authorised technicians. If this is not the case,
TECHNOGEL SpA declines any liability for changes or damages that may derive there from.
TECHNOGEL SpA declines any liability for the machine improper use, for damages caused by operations
not addressed in this manual or unreasonable.
1.4 ARRANGEMENTS BY THE CUSTOMER
Detailed operating instructions are provided in chapter 3 of this manual (INSTALLATION).
A simple list of the arrangements by the customer is provided herein.
Except for specific contractual agreements, the following are the customer's responsibility:
- arrangement of premises (including masonry work, foundations or any requested channelling, etc.);
- arrangement of the place of installation and machine installation;
- arrangement of adequate auxiliary services for system requirements (e.g. water, electric mains, etc.);
THIS MANUAL IS THE PROPERTY OF
–
TECHNOGEL SpA
ALL REPRODUCTIONS, EVEN PARTIAL, ARE FORBIDDEN
3
Page 3 of 52