Technogel Mixpasto 60 Use And Maintenance Instructions page 16

The "bain-marie" method is used with the product tray wrapped by a coil in which a heat-transmitting fluid
(glycol+water) flows.
The product is loaded from above by lifting the polycarbonate lid; discharge is through the tap located in the
front part of the machine.
The user decides the composition of the mix to be pasteurised: the percentage of the dry part (the density of
the mix) can influence the outcome of the cycle: it must not, however, exceed the limit of 42%.
ATTENTION
The machine must never operate empty!
4.1.3 Use of commands
The machine is powered by connecting its plug to the mains; it does not have a main switch.
Pressing the START button activates the electric power supply. The control panel's screen switches on (see
fig. 4.1) and show the installed SW + HW upgrade index.
The user interacts with the machine micro-processor by means of the commands shown in fig. 4.1, that is:
- the screen
- the buttons.
THIS MANUAL IS THE PROPERTY OF
Fig. 4.2
–
TECHNOGEL SpA
ALL REPRODUCTIONS, EVEN PARTIAL, ARE FORBIDDEN
16
Page 16 of 52