Cycle Programming - Technogel Mixpasto 60 Use And Maintenance Instructions

Press the "CYCLE START" key (pos. 2, fig. 4.1) to
start the machine, after having selected the wanted
cycle.
The thermometer symbol appears on the screen if
the program provides a heating phase; the snow
crystal symbol appears if it provides a cooling
phase.
The stirrer speed can be increased or decreased
with the LEFT ARROWS.

4.1.4 Cycle programming

The operator can pre-set 5 customised programs for each of which the process parameters must be fixed.
Select PROGRAM from the main menu and press ENTER: the next menu
appears providing 5 rows (see figure at side), to each of which corresponds one of
the special programs.
It is possible to customise one of the 5 programs indicated on screen:
YOGHURT Y
CHOCOLATE C
PROGRAM P1
PROGRAM P2
PROGRAM P3
Every program is structured in 6 steps or operating phases.
Every step can be set as heating or cooling phase (RAMP) or as maintenance in
constant temperature phase (STOP).
Select the chosen program using the LEFT ARROWS and then ENTER
(e.g. program Y: the menu relating to STEP 1 appears.
Select the T RAMP entry using the RIGHT ARROWS: when highlighted,
the T RAMP and T STOP entries alternate using the LEFT ARROWS.
The user chooses the type of phase to be attributed to the STEP in
question, then press ENTER to acquire the setting.
THIS MANUAL IS THE PROPERTY OF
–
TECHNOGEL SpA
ALL REPRODUCTIONS, EVEN PARTIAL, ARE FORBIDDEN
20
Page 20 of 52