Demolition And Disposal - Technogel Mixpasto 60 Use And Maintenance Instructions

3.6

DEMOLITION AND DISPOSAL

With regard to demolishing and disposal, remember that the materials constituting the machine are not
dangerous and mainly consist of:
- stainless steel
- copper
- plastic materials (polycarbonate, various isolators, etc.)
- refrigerant gas R404A
- glycol
- electric motors;
- electric cables with relative sheaths.
ATTENTION
Evacuate and dispose of the materials from the machine demolition by following the
relative standards in force for the protection of the environment.
Take the necessary precautions to prevent the dispersion of refrigerant gas from the
cooling system into the air. This operation must be carried out by authorised personnel,
following the procedures approved by the public authority.
3.6.1 Procedure for dismantling the machine
Proceed as follows should it be necessary to dismantle the machine for its demolition:
•
Consult the environmental protection laws in force in the user's country.
•
As legally prescribed, activate the inspection procedure by the Body in charge and the consequent
reporting of the demolition.
•
Group and separate the components according to their chemical nature.
•
Proceed with the scrapping in respect of the laws in force in the user's country.
•
During dismantling, carefully comply with the health and safety prescriptions of the operators.
ATTENTION
Dismantling must be carried out by qualified personnel.
ATTENTION
Different legislations are in force in different countries. Observe the prescriptions set by
the laws and the bodies in charge in the countries where the demolition occurs.
THIS MANUAL IS THE PROPERTY OF
–
TECHNOGEL SpA
ALL REPRODUCTIONS, EVEN PARTIAL, ARE FORBIDDEN
13
Page 13 of 52