IKA C 7000 Operating Instructions Manual page 66

0HVVDJH
WHVW QRW \HW SULQWHG
ORVV RI SRZHU VXSSO\
37 SDUDPHWHUV PLVVLQJ
9 WLPHG RXW
VFDOH WLPHG RXW
PHPRU\ KDV EHHQ
UHLQLWLDOL]HG
SUREOHP ZLWK FORFN
VWRUDJH
FORFN EDWWHU\ GHDG
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
&DXVH
You have attempted to change
the parameters of a test that has
not yet been printed out.
An interruption in the power
supply has been detected.
A test can only be carried out
after pre-test parameters have
been entered.
Data could not be sent through
the V24 interface to the PC.
Data could not be sent to the
balance, or the balance does not
respond.
After the program was started, a
memory error was detected, and
the memory reinitialized. Test
data have been erased.
After the program was started, a
memory error was detected in
the clock unit.
The clock unit battery is empty.
®
IKA -WERKE C 7000
5HPHG\
Print test at least once, and then
edit.
Possibly too many consumers are
connected to a single socket, which
has caused a brief voltage drop.
Connect C 7000 to a separate
socket.
Enter pre-test parameters.
Check that you have not entered the
wrong sample code.
Check interface parameters and
connection cable. Make sure that
external PC is ready.
Balance reading has not yet
stabilised. Check interface
parameters and connection cable.
If this problem occurs frequently, the
battery on the MC board must be
changed (by the Technical Service
Department or an instructed
specialist).
Check date and time, and reset if
necessary. If this problem occurs
frequently, the clock unit must be
changed (by the Technical Service
Department or an instructed
specialist).
The clock unit must be changed (by
the Technical Service Department or
an instructed specialist).
3DJH 
Ver. 07 09.07