IKA C 7000 Operating Instructions Manual page 65

3DJH 
0HVVDJH
QR LQFUHDVH LQ WHPSHUDWXUH 12 seconds after the start of the
PHDVXUHPHQW UDQJH
H[FHHGHG
PHDVXUHPHQW FDUG
GHIHFWLYH
PHDVXUHPHQW DOUHDG\
SHUIRUPHG
0HDVXUHPHQW VWDUWHG
SRVWWHVW SDUDPHWHUV
DOUHDG\ HQWHUHG
QR PHDVXUHPHQW
SHUIRUPHG \HW
VDPSOH FRGH LV DVVLJQHG
VDPSOH FRGH QRW IRXQG
PHPRU\ IRU WHVWV IXOO
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
&DXVH
main test, the temperature
increase is less than 0.2 K.
During a measurement, the
permissible temperature has
been exceeded.
Contacts of the decomposition
vessel (contact board) or the
calorimeters (contact pins) dirty
or damaged.
Measurement PCB defective.
Hardware fault on measurement
PCB
A sample code has been entered
for which a temperature increase
is already stored (by
measurement or manually).
This indicates the start of a
measurement.
Under this sample code, post-
test parameters are already
entered.
Post-test parameters can only be
entered after a test has been
made.
Under this sample code,
parameters are already entered.
The sample code entered could
not be found.
The available memory is full
(100 tests).
®
IKA -WERKE C 7000
 0HVVDJHV DQG 7URXEOHVKRRWLQJ
5HPHG\
Faulty ignition or vessel not filled
with oxygen.
Open vessel and check these points.
If the sample has burnt, the sample
was too small. Then increase size of
sample.
Reduce mass of sample.
Clean contacts, if damaged inform
Technical Service Department.
Inform Technical Service
Department.
Inform Technical Service
Department.
Enter sample code that has not yet
been used.
To change parameters, you can use
sub-menu HGLW in PHQX .
First carry out measurement or enter
temperature increase manually.
Enter sample code that has not yet
been used.
Enter valid sample code.
Erase tests no longer needed
(PHQX , sub-menu GHO).
Ver. 07 09.07