Security Configuration - Proxim Tsunami MP-8100 Series Installation And Management Manual

4.5 Security Configuration

4.5.1 Setting Up Wireless Security
In Wireless Security page, you can configure security mechanisms used to secure the communication link between the BSU
and SU. By default, a security profile (WORP Security) is preconfigured with the default configuration for WORP security.
However, more profiles can be created as required. Even though multiple security profiles can be created, only one security
profile can be active at a time. The active security profile is configured as part of the WORP property Security Profile Name.
For a security profile to be active, it must be enabled. Refer to
NOTE: The active security profile parameters on the BSU and SU should match for the connection to work as desired.
To configure the Wireless security properties
1. Click ADVANCED CONFIGURATION > Security > Wireless Security. The Wireless Security Configuration screen is
displayed as shown below.
2. Select the appropriate parameters. See the following table that lists the parameters and their descriptions.
3. Click OK.
Tsunami MP-8100 Installation and Management Guide
Configuring WORP Properties in BSU Mode
Figure 4-8 Wireless Security Configuration
Advanced Configuration
for details.
61