B Boot Loader Cli And Scantool - Proxim Tsunami MP-8100 Series Installation And Management Manual

Boot Loader CLI and ScanTool
Boot Loader CLI
The Boot Loader CLI is a minimal subset of the normal CLI used to perform initial configuration of the unit. The Boot Loader
CLI is available when the unit's embedded software is not running.
This interface is only accessible through the serial interface, if:
•
The device does not contain a software image
•
An existing image is corrupted
•
An automatic (default) download of image over TFTP has failed.
The Boot Loader CLI provides you with the ability to configure the initial setup parameters; and depending on this
configuration, a software file is downloaded to the device during startup.
The Boot Loader CLI supports the following commands:
•
factory_reset: Restore the factory settings
•
help: Print Online Help
•
reboot: Reboot the device
•
set: Set the parameters
•
show: Show the parameters
The Boot Loader CLI supports the following parameters (for viewing and modifying):
•
ipaddr: IP Address
•
systemname: System Name
•
gatewayip: Gateway IP Address
•
serverip: Server IP Address
•
ipaddrtype: IP Address Type
•
netmask: Net Mask
•
filename: Image file name (including the file extension)
If the Boot Loader fails to load the firmware from flash, it tries to get the firmware from the network. The default
configuration of the Boot Loader parameters are as follows:
ipaddr
netmask
gatewayip
systemname
serverip
filename
ipaddrtype
Tsunami MP-8100 Installation and Management Guide
Parameter Value
169.254.128.132
255.255.255.0
169.254.128.132
systemname
169.254.128.133
imagename
dynamic
B
191