File Management - Proxim Tsunami MP-8100 Series Installation And Management Manual

NOTE: The Input and Output Bandwidth features are referred with respect to the wireless interface. That is, input
bandwidth refers to the data received on the wireless interface and output bandwidth refers to the data sent out of
the wireless interface.

5.2 File Management

Using this section, you can upgrade the firmware or configuration of the device and also retrieve the log/configuration files
from the device. File Management can be done using TFTP (by using an external TFTP Server) using Web, CLI or SNMP. It can
also be done using the HTTP using Web Interface.
5.2.1 Upgrade Firmware via HTTP
For upgrading the firmware via HTTP web interface, click MANAGEMENT > File Management > Upgrade Firmware > HTTP.
Steps to upgrade the firmware via HTTP
1. Click Browse and locate the firmware file.
2. Click Update to initiate the HTTP Update operation.
A confirmation message prompts you that a reboot of the device is required for changes to take effect. Click OK and then click
COMMIT to reboot the device for changes to take effect.
NOTE:
• After upgrading new firmware, the device must be rebooted. Until a reboot occurs, the device will continue to run
the firmware it was using before the upgrade started.
• If the user navigates to another page before upgradation is complete, the user may not be able to use the
eventlog/syslog to confirm the status of update.
Tsunami MP-8100 Installation and Management Guide
Figure 5-4 HTTP Upgrade Firmware
System Management
131