Routing Features Configuration - Proxim Tsunami MP-8100 Series Installation And Management Manual

4.10 Routing Features Configuration

4.10.1 Static Route Table (Routing Mode Only)
The static routing table mechanism is available for BSU ans SU in routing mode only. It stores the route to various destinations
on the network. When packets are to be routed, the routing table is referred to for the destination address.
To set the static routing table
1. Click ADVANCED CONFIGURATION > Network > Static Route Table.
2. Enter the appropriate parameters. See the following table that lists the parameters and their descriptions.
3. Click Add to add a new entry in the table.
Route Status
Destination Address
Route Mask
Route Next Hop
Metric
Tsunami MP-8100 Installation and Management Guide
Figure 4-62 Netlp Static Route Table
Parameter
This parameter is used to enable or disable the static
Route Status. This parameter is applicable to all static
routes.
Specifies the destination IP address for which the static
route is to be made.
Specifies the subnet mask of the destination IP address.
Specifies the next hop IP Address through which route
is available to the destination IP address. Next hop IP
should belong to at least one of the subnets connected
to the device.
It is a metric that specifies the distance to the target
usually counted in hops. The priority is given to this
route relative to others. It can range from 0 – 16.
Description
Advanced Configuration
123