Wireless Configuration - Proxim Tsunami MP-8100 Series Installation And Management Manual

TxMode And Speed

4.4 Wireless Configuration

The MP-8100 series of devices use a proprietary Wireless Outdoor Router Protocol (WORP). WORP offers services based on a
polling algorithm, specially designed for wireless outdoor networks. WORP is designed to minimize the number of packets
being sent over the air by incorporating several mechanisms, like super-packeting and piggy-back acknowledgment in order
to achieve maximum throughput possible in the outdoor conditions.
A WORP-based device provides two modes of operations for establishing a wireless link, BSU and SU. Based on the mode of
operation at the interface, the respective parameters can be configured. The following sections describe the configurations
for BSU and SU.
4.4.1 Configuring WORP Properties in BSU Mode
To set the WORP properties
1. Click Advanced Configuration > Wireless > Interface1 > WORP. The WORP Configuration screen appears.
Tsunami MP-8100 Installation and Management Guide
Parameter Description
This parameter allows the user to select the speed and
mode based on the requirement for the corresponding
interface.
NOTE:
• Auto: Selects the best transmission mode
available when both sides are set to Auto.
• The recommended setting is Auto.
• In order to allow communication, the
transmitter
configured in same transmission modes.
• The maximum speed is measured as 1
gigabit per second.
Advanced Configuration
and receiver should be
49