Ethernet Properties Configuration - Proxim Tsunami MP-8100 Series Installation And Management Manual

4.3 Ethernet Properties Configuration

In the Ethernet Interface Properties screen, you can configure the Ethernet transmission properties. The recommended
settings are Auto for TxMode And Speed. The device supports two ethernet interfaces Ethernet 1 and Ethernet 2.
To configure the Ethernet Interface
1. Click ADVANCED CONFIGURATION > Ethernet. The Ethernet Interface Properties screen is displayed as shown
below.
2. Enter the appropriate parameters in the Ethernet Interface Properties screen. See the following table that lists the
parameters and their descriptions.
3. Click OK and then click COMMIT.
MAC Address
Operational Speed
Operational Tx Mode
Tsunami MP-8100 Installation and Management Guide
Figure 4-4 Wireless Ethernet Properties
Parameter Description
Displays the MAC address of the Ethernet interface.
Displays the current operational speed of the Ethernet
interface. The speed can be 1Gbps, 100 Mbps, or
10Mbps.
Displays the current operational transmit mode of the
Ethernet interface. There are 2 types of transmission
modes:
•
Half Duplex: Allows one-way transmission at
a time. Only receive or transmit operations
can be performed at once.
•
Full Duplex: Allows two-way transmissions
simultaneously.
Advanced Configuration
48