Configuration Backup; Configuration Restore - Proxim Tsunami MP-8100 Series Installation And Management Manual

7.3 Configuration Backup

You can back up the unit's configuration by retrieving the configuration file. You can use this file to restore the configuration
or to configure another similar unit (see
7.3.1 Through TFTP
1. Set up the TFTP server as described in TFTP Server Setup.
2. Access the unit as described in
3. Click Management > File Management > Retrieve From Device > TFTP tab.
4. Fill in the following details:
•
Server IP Address <IP address TFTP server>
•
File Name <configuration file name>
•
File Type <configuration file type>
5. Click Retrieve to start the file transfer.
The unit uploads the configuration file. The TFTP server program should show upload activity after a few seconds. When the
upload is complete, the configuration is backed up.
7.3.2 Through HTTP
1. Access the unit as described in
2. Click Management > File Management > Retrieve From Device > HTTP tab.
3. Fill in the following details:
•
File Type <configuration file type>
4. Click Retrieve to start the file transfer.
The unit uploads the configuration file. When the upload is complete, the configuration is backed up.

7.4 Configuration Restore

You can restore the configuration of the unit by downloading a configuration file. The configuration file contains the
configuration information of a unit. You can download a configuration file through TFTP or HTTP.
7.4.1 Through TFTP
1. Set up the TFTP server as described in TFTP Server Setup.
2. Access the unit as described in
3. Click Management > File Management > Upgrade Configuration> TFTP tab.
4. Fill in the following details:
•
Server IP Address <IP address TFTP server>
•
File Name <configuration file name>
5. Click Update/Update-Reboot to start the file transfer.
The unit downloads the configuration file. The TFTP server program should show download activity after a few seconds. In
case of Update and Reboot, when the upgrade is complete and the system rebooted, the configuration is restored.
7.4.2 Through HTTP
1. Access the unit as described in
2. Click Management > File Management > Upgrade Configuration > HTTP tab.
Tsunami MP-8100 Installation and Management Guide
Configuration Restore). You can update a configuration file through TFTP or HTTP.
Logging in to the Web Interface.
Logging in to the Web Interface.
Logging in to the Web Interface.
Logging in to the Web Interface.
Procedures
170