Network Configuration - Proxim Tsunami MP-8100 Series Installation And Management Manual

NOTE: Click COMMIT and REBOOT after changing any system parameter.

4.2 Network Configuration

Based on the selected mode of operation, the IP settings vary. When the device is in Bridge mode, only a single IP address is
required; but for Routing mode, individual IP address are needed for each of the Ethernet and Wireless interfaces. In Bridge
mode, the IP address can be statically assigned or dynamically obtained through DHCP; whereas in Routing mode, only static
assignment is supported.
4.2.1 Configuring IP in Bridge or Router Mode
To configure the Network IP properties
1. Click ADVANCED CONFIGURATION > Network > IP Configuration.
If the device is configured in Bridge mode, the following screen appears:
If the device is configured in Router mode, the following screen appears:
2. Enter the appropriate parameters in the IP Configuration screen. See the following table that lists and describes the
parameters.
3. Click OK. The IP configuration takes effect only after Reboot.
Tsunami MP-8100 Installation and Management Guide
Figure 4-2 IP Configuration in Bridge Mode
Figure 4-3 IP configuration in Router mode
Advanced Configuration
46