Connectors; Analog And S/Pdif; Analog; Ethernet - Netstreams DigiLinX Installation And Design Manual

DigiLinX Install and Design Guide
13-2
All specifications subject to change without notification. All rights reserved. Copyright © 2008 NetStreams
Figure 13-1 TheaterLinX front panel

Connectors

Figure 13-2 shows the connectors on the back panel of TheaterLinX
S/PDIF
Analog Pass
Pass Through
Through
In
S/PDIF
Analog In

Analog

In and Out
(Right and
Out
Left)
(Right and
Left)
Figure 13-2 TheaterLinX back panel
The following are the major functional areas of the back panel.

Analog and S/PDIF

Stereo audio output connections go to the receiver.
Analog
Input and output of the stereo analog audio with pass-through connections on the
inputs.

Ethernet

10/100 Ethernet connection that goes to the SwitchLinX.

A/V Receiver

This section includes a power sense connection like those used on an MLA101 (used to
determine if a device is powered), a pass-through for the power sense, an IR output
used to control the Receiver, and an RS-232 connection used to control the A/V
receiver.
Main +1 512.977-9393 / fax +1 512.977.9398 / Toll Free Technical Support +1 866-353-3496
3600 W. Parmer Lane, Suite 100; Austin, TX 78727 /
A/V
A/V
Receiver
Receiver
RS-232
Pass-
Ethernet
Through
A/V Display
Receiver
Pass-Through,
Sense and
Sense, and
IR
IR
www.netstreams.com.
Sources
IR
IR
Contact
1,2,3,4
Block
,
Closures
Output
NetStreams
Input
IR
Sensor
Receiver
Power