Connectors; Installation - Netstreams DigiLinX Installation And Design Manual

Connectors

Figure 11-2 shows the connections on the DX100.
Figure 11-2
The DoorLinX electronics package contains the connectors needed to connect the
DoorLinX into the DigiLinX network. Terminations for the DoorLinX include:
CAUTION!

Installation

To install DoorLinX, you must install the mounting bracket and the doorbell mounting
plate, connect the cables, and mount the electronics package, faceplate, and doorbell.
All specifications subject to change without notification. All rights reserved. Copyright © 2008 NetStreams
Main +1 512.977-9393 / fax +1 512.977.9398 / Toll Free Technical Support +1 866-353-3496
Ethernet (Network)
Connection
DoorLinX connections
Ethernet: RJ45 connectors, 568a termination standard
power: 2-pin Phoenix connector (provided)
The contact closure is rated to a maximum of 1A. Do not attempt to drive a
door strike directly from the contact closure. Connect another relay to the
DoorLinX contact closure and use the DoorLinX to trip this relay to run the
high-current door strike.
doorbell: 2-pin Phoenix connector (provided)
contact closure: 3-pin Phoenix connector (provided).
3600 W. Parmer Lane, Suite 100; Austin, TX 78727 /
2-pin 3.5mm
Phoenix
connector
3-pin 3.5mm
Phoenix connector
11-3
www.netstreams.com.
DoorLinX
Normally
Closed,
Closed,
Normally
Open
2-pin 5mm Phoenix
connector