Installing The Doorbell - Netstreams DigiLinX Installation And Design Manual

DigiLinX Installation and Design Guide
Figure 11-6
2.
3.
4.

Installing the Doorbell

The doorbell easily attaches to the mounting plate. To install the doorbell, complete the
following steps (refer to Figure 11-7):
1.
11-8
All specifications subject to change without notification. All rights reserved. Copyright © 2008 NetStream
thickness of the outer wall material, taking into account a tight seal for the gasket on the
faceplate.
Faceplate Mounting
DoorLinX
Slot
Electronics
(DX100)
2
Installing DoorLinX faceplate
Make all wiring connections, and then insert the DoorLinX electronics (DX100) into the
mounting box using the four mounting screws. Ensure that the faceplate mounting slot
faces up.
Fit the hanger bracket on the faceplate to the faceplate mounting slot on the DoorLinX
and push the faceplate down and towards the DoorLinX.
Push the faceplate against the DoorLinX so that it compresses the gasket. While
maintaining pressure, insert the set-screw at the bottom of the faceplate and screw in to
lock the faceplate in place.
Hang the doorbell faceplate's tab over the top of the mounting plate.
Main +1 512.977-9393 / fax +1 512.977.9398 / Toll Free Technical Support +1 866-353-3496
3600 W. Parmer Lane, Suite 100; Austin, TX 78727 /
Wall Stud
Cutaway of
Wall
1
Faceplate
Mounting Bracket
(DXB100)
www.netstreams.com.
Wall
Faceplate
3
4
Adjust depth
DoorLinX
as needed
Wall
Stud
DoorLinX
Backbox