Aerotech BA-SineDrive Series User Manual page 12

BA SineDrive User's Manual
DECLARATION OF CONFORMITY
Manufacturer's Name and Address
Aerotech, Inc.
101 Zeta Drive
Pittsburgh, PA 15238-2897
Declares that the product:
Product Name: BA Intellidrive/BA Sinedrive
Conforms to the following product specifications:
EMC: EN 55011: Class B Emissions
LVD:
and complies with EMC directive 89/336/EEC.
Pittsburgh, PA
October 8, 1998
General notes concerning the test setup.
This product was tested at Compliance Labs, Middlefield, OH on October 8, 1998.
The brushless amplifier was tested with a brushless servo motor. To ensure that the
product passes the conducted emissions tests, a line filter and common mode choke must
be connected to the main inputs. The filter is a Schaffner FN 2070-10-06 and the common
mode choke is a Renco Electronics RL-1329-1200. Ferrite must be added to each line of
the main inputs but not earth ground. In order for the product to conform to the radiated
emission standards, the motor cable must be shielded and the shield must be tied to the
earth ground. Ferrite must also be added (in common mode) to the motor cable but not
around the shield. Finally, a metal 25-pin connector with a metal backshell must be used
when making a connection to the 25-pin receptacle on the amplifier. The shield of the
feedback cable must be tied to the metal backshell. Failure to follow the described
procedures may cause the amplifier/motor to exceed emission limits.
Version 1.4
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
EN 50082-1: Immunity
EN61000-4-2
EN61000-4-3
EN61000-4-4
EN61000-4-11
EN50141
IEC 204-1
David F. Kincel_________________________
Quality Assurance Manager
Robert Novotnak__________________________
Engineer Verifying Compliance
∇ ∇ ∇
Aerotech, Inc.
Regulatory Information
xi