Table of Contents
Advertisement
BA SineDrive User's Manual
5.6.1. Mounting Procedures for the BAS 10/20/30/50
To ensure proper heat dissipation, Aerotech recommends the following procedures.
1.
Use the mounting procedure shown in Figure 5-18. The wider part of the amp should
be mounted to the heat sink.
2.
Heat sink should be at least 2 feet
3.
The heat sink should be free of paint or any other thermal
4.
The heat sink must be flat to allow good thermal conductivity between the heat sink
and the amplifier.
5.
If possible, add a thermal conductivity enhancer (i.e., thermal grease between the
heat sink and the amplifier).
6.
Adding an external fan will remove a considerable amount of heat from the heat sink
and allow the amplifier to operate at a much cooler temperature.
0.35
IW
.18
Figure 5-17.
Version 1.4
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
2
x0.25 inch thick minimum.
IW
7.00
7.35
BAS Amp Top View (Preferred Mounting, 10/20/30/50)
Aerotech, Inc.
Technical Details
rrier.
ba
0.18
Heat Sink
5-17
Advertisement
Table of Contents
