Chapter 2: Configuration And Communication; Introduction; Bas Control Board Jumper Selections; Table 2-1. Power Board Jumper Selections - Aerotech BA-SineDrive Series User Manual

BA SineDrive User's Manual

CHAPTER 2: CONFIGURATION AND COMMUNICATION

In This Section:

• Introduction ........................................................................................ 2-1

• BAS Control Board Jumper Selections ............................................... 2-1

• BAS Communications Modes ............................................................. 2-2
• Menu Commands................................................................................. 2-3
2.1. Introduction
This chapter covers the jumper configurations when used with a brushless DC motor.
2.2. BAS Control Board Jumper Selections
The only user selectable jumper on the BAS Amplifier board is JP2. The jumper selects
between shunt and no shunt regulator.
Remove power from unit before changing the jumper.
The user selectable jumper on the power board is shown in Table 2-1.
Table 2-1. Power Board Jumper Selections
Jumper
JP2
The only user selectable jumper on the control board is JP2. It selects the input common
resistance. Refer to Table 2-2.
Table 2-2. Control Board Jumper Selections
Jumper
JP2
Version 1.4
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Configuration and Communication
Position
1-2
2-3 Shunt board installed
Position
1-2
2-3
Aerotech, Inc.
Mode
No shunt
Mode
5V Opto input
24V Opto input
DANGER

JP2
BAS Power Board

JP2
BAS Control Board
2-1