Installation Overview; Mounting The Vsw 2Vga A; Rack Shelf Mounting - Extron electronics VSW 2VGA A User Manual

im Vertrieb von
Installation and Operation

Installation Overview

To install and set up the VSW 2VGA A for operation, follow
these steps:
1
2
3
4
5
6

Mounting the VSW 2VGA A

When mounting the switcher, take cabling and power
availability into consideration. Select rack shelf, under-desk
(optional), through-desk (optional), or projector bracket
(optional) mounting. Follow the appropriate mounting
procedure on the following pages.

Rack shelf mounting

1.
2.
www.camboard.de
VSW 2VGA A • Installation and Operation
2-2
CAMBOARD Electronics
Turn all of the equipment off. Make sure that the
video and audio sources (computers, stereos, tape
decks, or other devices), the VSW 2VGA A,
the output devices (projectors, speakers), and the contact
closure control device are all turned off and
disconnected from the power source.
Mount the switcher. See "Mounting the VSW 2VGA A" in
this chapter.
Attach the cables. See "Rear Panel Features and Cabling"
in this chapter.
Connect power cords and turn on the devices in the
following order: output devices, contact closure controller,
VSW 2VGA A switcher, and input devices.
Select an input using the front panel input toggle switch or
the contact closure controller.
The image should now display, and sound should be
audible. If not, ensure that all devices are plugged in and
receiving power. Check the cabling and make adjustments
as needed. Select a different input to check for a picture
and sound. See "Troubleshooting" in this chapter.
If feet were installed on the bottom of the switcher, remove
them.
Mount the VSW 2VGA A on a VersaTools ® 19" 1U Rack
Shelf (part #60-190-20 or #60-604-20), a 1U 6" Deep
Rack Shelf (part #60-190-01 or 60-604-10), or a standard
Universal 1U Rack Shelf (part #60-190-01 or #60-604-01).
On the standard rack shelf, the switcher mounts in one
of four locations to the rear of the rack or in one of four
locations to the front of the rack.
Tel. 07131 911201
Fax 07131 911203
ce-info@camboard.de