Projector Mounting; Pmk 100 Mini Projector Mount Kit - Extron electronics VSW 2VGA A User Manual

im Vertrieb von
Installation and Operation, cont'd
4.
5.
6.
Figure 2-4 — Through-desk mounting
7.

Projector mounting

To projector-mount the VSW 2VGA A, three optional mounting
kits are available.

PMK 100 Mini Projector Mount Kit

The PMK 100 is a projector mounting kit (part # 70-217-01)
designed for use with Extron 1U high, quarter-rack width
products like the VersaTools products. It allows them to be
mounted near or on a projector support.
www.camboard.de
VSW 2VGA A • Installation and Operation
2-6
CAMBOARD Electronics
Hold the switcher with attached brackets up against the
underside of the desk or table. Use a soft pencil to mark
the locations of the holes for the screws that will attach the
brackets to the desk.
Drill ¼" (6 mm) deep, 3/32" (2 mm) diameter pilot holes in
the desk or table at the marked screw locations. The holes
should be drilled from the underside or inside (concealed
side) of the furniture, where the switcher will be located.
Attach the switcher to the desk/table with the provided
wood screws, as shown in figure 2-4.
To adjust the height of the switcher within the desk,
slightly loosen the screws that attach the brackets to the
switcher, adjust the height by sliding the switcher up or
down, and retighten the screws.
Tel. 07131 911201
Fax 07131 911203
ce-info@camboard.de