Pmk 300 Projector Mount Kit - Extron electronics VSW 2VGA A User Manual

im Vertrieb von CAMBOARD Electronics
9. Secure the back brace to the square U-bolt using the
included hex nuts, washers, and lock washers. Tighten the
hex nuts securely.
10. Secure the front panel to the mounting tray with four of the
included #6 screws.
11. If desired, choose one of the provided four sizes of self-
adhesive cover sheets, and apply it to the underside of the
mounting tray.

PMK 300 Projector Mount Kit

The PMK 300 Multi-Product Projector Mount Kit (#70-374-01)
mounts up to three quarter-rack width products to a projector
ceiling mount pole. The VSW 2VGA A can be mounted above
the display device with the front panel facing either down or
up. The quarter rack width plate can also be used to mount the
switcher's external desktop power supply.
Follow these steps to projector-mount the switcher using the
PMK 300:
1. If necessary, remove the feet from the bottom of the
switcher.
2. Mount the switcher to one of the bracket's three mounting
plates. It can be vertically mounted facing either up or
down, whichever is more convenient. See figure 2-7.
• On the side mounting plates, the switcher is typically
• For the VSW 2VGA A unit, use two of the supplied
3. Place the U-bolt around the ceiling pole and insert the two
legs of the U-bolt through the slotted holes on the bracket's
mounting plate, then through the round holes on the
backing brace.
• For a typical (1.5" to 2.0" diameter) pole — You can use
www.camboard.de Tel. 07131 911201
Fax 07131 911203
Be sure to tighten the hex nuts securely enough that the
PMK 250 does not slide down the ceiling pole. A socket
wrench is recommended to tighten the hex nuts.
mounted on the outside of the bracket.
On the front mounting plate, the device is typically
mounted on the inside of the bracket.
4-40 x 3/16 screws in opposite (diagonal) corners to
secure the device to the bracket.
For the switcher's power supply, use the two included
tie wraps to strap the power supply to the bracket.
the supplied square U-bolt, which fits a typical ceiling
pole.
ce-info@camboard.de
VSW 2VGA A • Installation and Operation
2-9