Cascade C Series User Manual page 24

ADVANCED WEIGHING OPERATIONS
Piece Count (Sampling Method) (continued)
7
The screen will show "AddPCS". Press "NET/GROSS" button.
NOTE: If "AddPCS" does not show, press the "ON/PRINT"
button until "AddPCS" shows.
8
The indicator will show "5" (default value). To sample with
a different quantity, refer to the "Configuration Mode Button
Functions" (below) to change the quantity. To accept the
default or entered value, press "NET/GROSS" button.
Configuration Mode Button Functions
To change quantity:
Increase
Value
9
The indicator will show the sample load quantity, as
entered, and "pcs" icon.
NOTE: The indicator will show "–Lo_" briefly when APW
is too light and can not be sampled.
10
Remove the sample load and add a load to count on
the pallet (or into bin).
11
The indicator will show the quantity of the load.
12
Continue to acquire load quantities with the same
sample APW. To exit this mode, press the "UNITS"
button.
NOTE: The indicator does not retain APW after exiting
this mode or being turned off.
22
Decrease Accept Shift to the
Value Value next digit,
left
Press to continue
Shift to the
next digit,
right
12
To exit Piece
Count Mode
7
Press only if "AddPCS"
does not show.
8
Press to accept default quantity
9
Quantity (default or entered)
10
11
Load's
weight
shows
after
exiting
FK0773.eps
8305557-R2