Siruba Sew Reach ABF Series Instruction Book / Parts List page 51

3.出現 錯誤代 碼E42： 送 鈕 機構故 障
檢查磁簧開關安 進入參數A02檢查感測器是
裝位置是否正
否有亮滅反應或以一字起子
NO
確？
接觸感測器上LED有無亮滅
If the
installation of
Enter the parameter A02
the reef switch
detector to check if it can
is correct？
work; check if the LED on
extinguish by touching it
NO
with a slotted screwdriver.
調整磁簧開關 檢查I/O板上IN3位置訊號線
Adjust the reef
Check If the IN3 position
switch.
signal wire on the I/O board
Connect the signal wire
4.出 現錯 誤代 碼E43 ： 最 大尺 寸 安全 保 護
開關 異常
檢查安全開關位
檢查I/O板上IN7位置訊號線
置是否正確？
YES
Is the position
Check If the IN7 position
of the safety
signal wire on the I/O board
switch is
accurate？
NO
重新接妥訊號線並檢查有無
調整安全開關到
正確位置
Reconnect the signal wire
Adiust the
safety switch to
the accurate
position
反應？
the sensor can be lit or
NO
鬆脫？
is loose？
YES
接妥訊號線重新測試
appropriately and test
again.
鬆脫？
is loose？
YES
接觸不良問題
and check if there is a
problem of connection
-45-
3.Display the error code E42
of the feeding button mechanism
檢查ABF控制基板
是否有DC24V電 NO
YES
壓？
Check if the
DC24V voltage is
in the ABF
control board.
YES
更換ABF機台內控
制基板
Replace with
another control
board in the ABF
machine
4.Display the error code E43
size of safety protection switch is abmormal.
檢查I/O板是否有
DC24V電壓？
NO
NO
Check if the
DC24V voltage is
in the I/O board.
YES
更換ABF機台內
控制基板
Replace with
another control
board in the ABF
machine
Introduction
The breakdown
：
檢查連接至主機之
訊號線或更換I/O板
後重新再測一次？
Check the signal
wire connected to
the motherboard or
substitute the I/O
panel and test
again.
The maximum
：
更換I/O板
後重新再測一次？
Substitute another
I/O panel and test
again.
P45