Siruba Sew Reach ABF Series Instruction Book / Parts List page 43

(2)A02傳感器訊號檢驗
按參數設定鍵 按項目選擇鍵
Press the Press the Item
parameter Selection Key.
setting key.
手動檢測各訊號該數字點
有閃滅表示sensor正常
Manually detect each
signal. If the points of
numbers glitter, it
indicates the sensor is
normal.
(3)A03送鈕撥爪定位校正（啟動此參數，請
先將BT290作home ，否則會有誤動作撞
機的情況產生）
按參數設定鍵 按項目選擇鍵
Press the Press the Item
parameter Selection Key.
setting key.
按項目選擇鍵
爪送出，請轉動手轉軸對正送
鈕撥爪正中心
Press the item selection key
and sending the feeding
plate. Please turn the turning
bar to locate to the center of
the feeding clamp.
注意：送鈕撥爪中心點需與機針同心，如有
偏差容易造成斷針或鈕扣破裂。
此時畫面出現
displays A02.
1:送釦軌道定位開關
1: Sensor of Positioning The Feeding Track
2 氣源偵測感測器 :
2: Air detecting sensor
3 旋臂原點位置開關 :
3: Sensor of The Rotary Arm
4 手動按鈕訊號 :
4: Manual Button Signal
5 切刀原點位置開關 :
5: Sensor of The Trimmer Initial Position
6 夾爪上釦開關 :
6: Buttons on the clamp
7 軌道開度極限開關 :
7: Sensor of The Track Width
此時畫面出現
A03
The panel
displays A03.
，此時送鈕撥 按項目選擇鍵
鈕撥爪回復原點
Press the item selection
key
plate back to the initial
position.
-37-
(2)A02 Examine the Sensor Signal
按準備鍵進入設定
A02 Press ready key for
The panel
(3)A03 Adjust the position of the feeding plate.
(Activate this parameter. Please set BT290
as HOME, or it is easy to cause the error.)
按準備鍵進入設定
Press ready key for
setting
，此時送
按M鍵2次回主畫面
Press the M key
twice to be back
and the feeding
the main window..
Note:The central point of the feeding plate
should be aligned to the needle;
otherwise, it is easy to cause the broken
needle or the buttons damaged.
Introduction
setting
按M鍵2次回主畫面
Press the M key
twice to be back
the main window..
P37