Siruba Sew Reach ABF Series Instruction Book / Parts List page 49

(13)H41氣源偵測設定
按M鍵5秒進入H參數
Press the M key for
5 sec to enter the
parameter H.
H41
按項目選擇鍵
Press the Item Selection Key
to choose the air-resource
detection ON.
按準備鍵儲存
Press the Ready
Key to save.
(14)H42 夾爪上釦設定
H42
按M鍵5秒進入H參數
H42
Press the M key for
5 sec to enter the
parameter H.
Enter the panel
H42
按項目選擇鍵
偵測功能關
Press the item selection button
to deactivate the button
detection function.
注意：當H42設為ON時,若縫製模式下,夾爪
上無鈕釦,則出現E48警示.需在夾爪上
放上鈕釦才可繼續縫製
H41
選擇H41
Select H41
選擇氣源偵測開 按項目選擇鍵
Press the Item Selection Key
detection OFF.
按M鍵2次回主畫面
Press the M key twice
to be back the main
window.
det-
ON
OR
det-
按準備鍵進入設定
OFF
Press ready key for
進入畫面H42
H42.
det-
OFF
選擇夾爪上釦
-43-
(13)H41 parameter setting of air detecting
按準備鍵進入設定
Press ready key for
setting
H41
選擇氣源偵測關
to choose the air-resource
(14)H42 Setting of buttons on the clamp
按項目選擇鍵
偵測功能開
Press the item selection button
setting
to activate the button
detection function or the clamp.
按準備鍵儲存
Press the Ready
Key to save.
Note: When setting H42 as ON, with the
sewing mode, if there is no button on the
clamp, it will display the warning E48 .
The sewing won't continue until putting a
button on the clamp.
Introduction
det-
ON
H42
選擇夾爪上釦
按M鍵2次回主畫面
Press the M key twice
to be back the main
window.
P43