Siruba Sew Reach ABF Series Instruction Book / Parts List page 47

(9)U27雷射燈亮度調整
按M鍵進入U參數
Enter the parameter
U by pressing the M
key.
U27
按項目選擇鍵
0 :關閉
1 :最暗
15:最亮
Press the item selection button
to choose 0~15
0 : Shut down
1 : the darkest
15 : the brightest
注意：參數配合出機械夾具規格設定，請勿
任意變更設變，避免產生誤動作。
(10)U28延遲送釦設定
按M鍵進入U參數
Enter the parameter
U by pressing the M
key.
U28
按項目選擇鍵
0 ~ 2000(ms): (每次增減100)
0 :不延遲
2000:延遲2000(ms)
Press the item selection button
to choose
0 : No delay
2000 : delay for 2000(ms)
(9)U27 Adjust the light of the laser
XX
+ -
U27
U27雷射燈亮度調整
U27 Adjust the light of
the laser
XX
+ -
選擇 0 ~ 15: 按準備鍵儲存
Press the Ready
Note: The parameter coordinates with the
(10)U28 Setting of delaying feeding-buttonser
XXX
U28
U28延遲送釦設定
U28 Setting of
delaying feeding-
buttons
XXX
選擇 按準備鍵儲存
Press the Ready
-41-
Introduction
按準備鍵進入設定
Press ready key for
setting
按M鍵1次回主畫面
Press the M key
once to be back
Key to save.
the main window.
default specification setting of the
mechanical clamp. Please do not
change the setting for avoid the error.
按準備鍵進入設定
Press ready key for
setting
按M鍵2次回主畫面
Press the M key
twice to be back
Key to save.
the main window.
P41