Block Diagram Of Simple Repair - Siruba Sew Reach ABF Series Instruction Book / Parts List

簡 易 維 修流 程圖
1.出 現錯誤 代碼E20 ： 操 作盒與ABF機 台控
制基板 通訊 異常
ABF主機電源已
開啟？
YES
Is the power
supply in the
ABF machine
turned on？
NO
開啟電源？
Turn on the
power supply
2.出現 錯誤代 碼E41 ： 送 鈕扣 機馬 達 原 點
檢索錯 誤
檢查I/O板上
IN1感測器連接
器有無鬆脫？
If the IN1
sensor
connector on
the I/O board is
loose？
YES
接妥後重新測
試？
Connect
appropriately
and test again.
P44
檢查ABF主機與BT290主機
訊號線是否連接？
Check if the signal wire
between the ABF machine
and the BT290 is
connected.
NO
重新接妥信號線並檢查有無
接觸不良的問題
Reconnect the signal wire
appropriately and check if
there is a problem of the
connection.
進入參數A02檢查感測器是
否有亮滅反應或以一字起子
NO
接觸感測器上LED有無亮滅
反應？
Enter the parameter A02
detector to check if it can
work; check if the LED on
the sensor can be lit or
extinguish by touching it
with a slotted screwdriver.
NO
更換感測器
Replace with another
sensor.
BLOCK DIAGRAM OF
SIMPLE REPAIR
1.Display the error code E20
The communication between the operation
and the control board of ABF machine is
abnormal.
檢查ABF控制基板
是否有DC24V電
YES
壓？
Check if the
DC24V voltage is
in the ABF
control board.
YES
更換ABF內主機板
Substitute
another ABF
motherboard
2.Display the error code E41
error of the feeding button motor origin.
檢查步進馬達
STEP1連接器是否
YES
鬆脫？
If the STEP1
connector on the
stepping motor is
loose.
YES
重新接妥訊號線
並檢查有無接觸
不良問題
Reconnect the
signal wire and
test if there is a
problem of
connection
-44-
：
檢查ABF主機與
NO BT290主機訊號線
是否連接？
Check if the signal
wire between the
ABF machine and
the BT290 is
connected.
The detection
：
更換ABF內之電源
供應器後重新再測
NO
一次
Substitute another
ABF switch power
and test again.
NO
更換ABF機台內控
制基板
Replace with
another control
board in the ABF
machine