Siruba Sew Reach ABF Series Instruction Book / Parts List page 44

(4)A04更換橡膠座(此機種不適用)
按參數設定鍵
Press the
parameter
setting key.
按項目選擇鍵
此時可更換橡膠座
Press the item selection key
, and send the rubber plate.
Meanwhile, change the
rubber plate.
(5)A05送鈕測試模式開放
按參數設定鍵
Press the
parameter
setting key.
按項目選擇鍵
或1開放手動送鈕測試模式
Press the Item Selection Key
to 0 turn off or 1 turn on
the manual feeding test
mode.
注意：車縫前需確定A05參數，需設定在零
否則無法進行車縫。
P38
按項目選擇鍵 此時畫面出現
Press the Item
Selection Key. The panel
displays A04.
，橡膠座送出 按項目選擇鍵
Press the item selection
key
plate back the initial
point.
按項目選擇鍵 此時畫面出現
Press the Item
Selection Key. The panel
displays A05.
選擇0關閉
(4)A04 Change the rubber plate.
(Not applicable for this machine type)
按準備鍵進入設定
A04 Press ready key for
setting
橡膠座回
復原點
, and the rubber
(5)A05 Turn on the Feeding Test Mode.
按準備鍵進入設定
A05 Press ready key for
setting
按準備鍵儲存
Press the Ready
Key to save.
Note: Be sure of the parameter A05 before
sewing. It is necessary to be set at 0;
otherwise, it couldn't start sewing.
-38-
按M鍵2次回主畫面
Press the M key
twice to be back
the main window..
按M鍵1次回主畫面
Press the M key
once to be back
the main window..