Designated Use; Target Group; Service - Festo CPX-FB32 Electronic Manual

Contents and general instructions

Designated use

Target group

Service

Festo P.BE−CPX−FB32−EN en 0605NH
The field bus node type CPX−FB32 described in this manual
has been designed exclusively for use as a slave on the
EtherNet/IP.
The CPX terminal may only be used as follows:
as designated in industrial applications
without any modifications by the user. Only the conver
sions or modifications described in the documentation
supplied with the product are permitted.
in faultless technical condition.
The maximum values specified for pressures, temperatures,
electrical data, torques etc. must be observed.
If additional commercially−available components such as
sensors and actuators are connected, the specified limits for
pressures, temperatures, electrical data, torques, etc. must
not be exceeded.
Please comply with national and local safety laws and
regulations.
This manual is intended exclusively for technicians trained in
control and automation technology who have experience in
installing, commissioning, programming and diagnosing
slaves on the EtherNet.
Please consult your local Festo repair service if you have any
technical problems.
VII