Configuring The Device; Inserting/Removing The Microsd Card - Siemens SIMATIC NET RUGGEDCOM RSG2488F Installation Manual

Device Management
3.2 Configuring the Device
The management port is a 10/100Base-TX copper Ethernet port with an RJ45 connec-
tor. The following is the pin-out for the management port:
8
Figure 3.2
Communication Ports
Connect any of the available Ethernet ports on the device to a management switch
and access the RUGGEDCOM RSG2488F console and Web interfaces via the device's
IP address. The factory default IP address for the RUGGEDCOM RSG2488F is
192.168.0.2.
For more information about available ports, refer to
3.2

Configuring the Device

Once the device is installed and connected to the network, it must be configured. All
configuration management is done via the RUGGEDCOM RSG2488F interface. For
more information about configuring the device, refer to the RUGGEDCOM RSG2488F
User Guide associated with the installed software release.
3.3

Inserting/Removing the MicroSD Card

The RUGGEDCOM RSG2488F accepts a microSD card for storing configuration files
and/or software updates.
Configuration hazard – risk of data loss
The microSD card must not be removed or replaced during normal operation of the
device. Make sure the device is powered down before removing or inserting the
card.
Mechanical/electrical hazard – risk of damage to the microSD card
•
20
1
RJ45 Management Port
CAUTION
CAUTION
Do not expose the microSD card to extreme temperatures or humidity
Pin Name
1 TX+
2 TX-
3 RX+
4 Reserved (Do Not Connect)
5 Reserved (Do Not Connect)
6 RX-
7 Reserved (Do Not Connect)
8 Reserved (Do Not Connect)
"Modules (Page
Installation Manual, 11/2019, C79000-G8976-1351-05
Description
Transmit Data+
Transmit Data-
Receive Data+
Receive Data-
https://-
23)".
RUGGEDCOM RSG2488F