Back To Factory Defaults; Restart Screen - ZyXEL Communications NBG-418N v2 User Manual

Fig ure 109
The NBG-418N v2 automatically restarts in this time causing a temporary network disconnect. In some
operating systems, you may see the following icon on your desktop.
Fig ure 110
If you uploaded the default configuration file you may need to change the IP address of your computer
to be in the same subnet as that of the default NBG-418N v2 IP address (192.168.1.1 in router mode). See
Appendix D on page 178
If the upload was not successful, the following screen will appear. Click
C o nfig ura tio n
Fig ure 111
20.4.3 Ba c k to Fa c to ry De fa ults
Pressing the
returns the NBG-418N v2 to its factory defaults.
You can also press the
418N v2. Refer to
20.5 Re sta rt Sc re e n
System restart allows you to reboot the NBG-418N v2 without turning the power off.
Ma inte na nc e > T o o ls
Click
the NBG-418N v2's configuration.
Configuration Restore Successful
Temporarily Disconnected
for details on how to set up your computer's IP address.
screen.
Configuration Restore Error
Re se t to de fa ult button in this section clears all user-entered configuration information and
WPS/ RESET
button on the rear panel to reset the factory defaults of your NBG-
Section 1.4.1 on page 14
Re sta rt
> . Click
NBG-418N v2 User's Guide
Chapter 20 Tools
for more information on the
Re sta rt
to have the NBG-418N v2 reboot. This does not affect
144
Re turn
to go back to the
WPS/ RESET button.