Resetting The Nbg-418N V2 To Its Factory Defaults - ZyXEL Communications NBG-418N v2 User Manual

Check the hardware connections, and make sure the LEDs are behaving as expected. See the Quick
1
Start Guide and
Reboot the NBG-418N v2.
2
If the problem continues, contact your ISP.
3
The Internet connection is slow or intermittent.
There might be a lot of traffic on the network. Look at the LEDs, and check
1
NBG-418N v2 is sending or receiving a lot of information, try closing some programs that use the Internet,
especially peer-to-peer applications.
Check the signal strength. If the signal strength is low, try moving the NBG-418N v2 closer to the AP if
2
possible, and look around to see if there are any devices that might be interfering with the wireless
network (for example, microwaves, other wireless networks, and so on).
Reboot the NBG-418N v2.
3
If the problem continues, contact the network administrator or vendor, or try one of the advanced
4
suggestions.
23.4 Re se tting the NBG - 418N v2 to Its Fa c to ry De fa ults
If you reset the NBG-418N v2, you lose all of the changes you have made. The NBG-418N v2 re-loads its
default settings, and the username/password resets to
changes again.
You will lose all of your changes when you push the
To reset the NBG-418N v2,
Make sure the power LED is on.
1
WPS/ RESET
Press the
2
configurations on the NBG-418N v2.
If the NBG-418N v2 restarts automatically, wait for the NBG-418N v2 to finish restarting, and log in to the
Web Configurator. The username is
If the NBG-418N v2 does not restart automatically, disconnect and reconnect the NBG-418N v2's power.
Then, follow the directions above again.
Chapter 23 Troubleshooting
Section 1.3 on page 13.
button for longer than 10 second to reboot and restore factory-default
a dm in
NBG-418N v2 User's Guide
a dm in 1234
/
WPS/ RESET button.
1234
and password is .
152
Section 1.3 on page
. You have to make all of your
13. If the