Back To Factory Defaults - ZyXEL Communications NBG4115 User Manual

After you see a "configuration upload successful" screen, you must then wait one minute before
logging into the NBG4115 again.
Figure 115 Configuration Restore Successful
The NBG4115 automatically restarts in this time causing a temporary network disconnect. In some
operating systems, you may see the following icon on your desktop.
Figure 116 Temporarily Disconnected
If you uploaded the default configuration file you may need to change the IP address of your
computer to be in the same subnet as that of the default NBG4115 IP address (192.168.1.1). See
Appendix C on page 215
If the upload was not successful, the following screen will appear. Click Return to go back to the
Configuration screen.
Figure 117 Configuration Restore Error

23.3.3 Back to Factory Defaults

Pressing the Reset button in this section clears all user-entered configuration information and
returns the NBG4115 to its factory defaults.
You can also press the RESET button on the rear panel to reset the factory defaults of your
NBG4115. Refer to the chapter about introducing the Web Configurator for more information on the
RESET button.
NBG4115 User's Guide
for details on how to set up your computer's IP address.
Chapter 23 Tools
179