Advanced Screen - ZyXEL Communications NBG-418N v2 User Manual

The following table describes the labels in this screen.
Table 58 Management > Bandwidth MGMT > Bandwidth MGMT
L ABEL
Service Management
Enable Bandwidth
Management
Apply
Reset
17.5 Adva nc e d Sc re e n
Use this screen to set up the QoS rules for the NBG-418N v2. Click
Adva nc e d . The following screen displays.
Fig ure 100
The following table describes the labels in this screen.
Table 59 Management > Bandwidth MGMT > Advanced
L ABEL
QoS Setup
Total Bandwidth (0,
Unlimited)
Up Stream
Down Stream
Apply
Reset
QoS Rules
#
Source IP Address
Max Bandwidth(kpbs)
Up Ceiling
Chapter 17 Bandwidth MGMT
DESC RIPT IO N
Click the Ena b le Ba ndwidth Ma na g e m e nt
management feature in the NBG-418N v2.
Click Apply to save your changes in t his screen.
Click Re se t to begin configuring this screen afresh.
Management > Bandwidth MGMT > Advanced
DESC RIPT IO N
This field shows the maximum number of data in kbps the NBG-418N v2 is allowed to send out
and allowed to come in through a source interface.
Type the Up Stre a m
through the source interface on the NBG-418N v2.
Type the Do wn Stre a m
go through the source interface on the NBG-418N v2.
Click Apply to save your changes back to the NBG-418N v2.
Click Re se t to begin configuring this screen afresh.
This field shows the index number of the QoS rule.
This field shows the source IP Address of the data traffic.
This field shows the maximum outgoing transmission data rate (kbps) that is allo wed to go
through the source interface on the NBG-418N v2.
NBG-418N v2 User's Guide
check box to activate the bandwidth
or maximum outgoing transmission data rate (kbps) that is allowed to go
or maximum incoming transmission data rate (kbps) that is allowed to
134
Ma na g e m e nt Ba ndwidth MG MT >
>