Wireless Lan Advanced Screen; Wps Screen - ZyXEL Communications NBG-418N v2 User Manual

6.6 Wire le ss L AN Adva nc e d Sc re e n
Use this screen to allow intra-BSS networking and set the RTS/CTS Threshold.
Click Ne two rk
Fig ure 48 Network > Wireless LAN > Advanced
The following table describes the labels in this screen.
Table 24 Network > Wireless LAN > Advanced
L ABEL
Wireless Advanced Setup
Tx Power
Enable Intra-BSS
Traffic
Apply
Reset
6.7 WPS Sc re e n
Use this screen to enable/disable WPS, view or generate a new PIN number and check current WPS
status. To open this screen, click
Chapter 6 Wireless LAN
> Wire le ss L AN > Adva nc e d
DESC RIPT IO N
This field controls the transmission power of the NBG-418N v2. If there is a high density of APs in
an area, decrease the output power of the NBG-418N v2 to reduce interference with other
APs.
A Basic Service Set (BSS) exists when all communications between wireless clients or between
a wireless client and a wired network client go through one access point (AP).
Intra-BSS traffic is traffic between wireless clients in the BSS. When Intra-BSS is enabled, wireless
client A and B can access the wired network and communicate with each other. When Intra-
BSS is disabled, wireless client
communicate with each other.
Click Apply to save your changes to the NBG-418N v2.
Click Re se t to reload the previous configuration for this screen.
Ne two rk
NBG-418N v2 User's Guide
. The screen appears as shown.
A and B can still access the wired network but cannot
> Wire le ss L AN > WPS tab.
69