Regular Maintenance - Tiger CNH T6010-80 Mounting And Operating Instructions

Regular Maintenance

The intervals at which regular servicing should be done are based on hours of operation. Use the tractors hour
meter to determine when regular servicing is required.
Refer to the Detailed Maintenance section for futher instructions on greasing. Copy and use the Daily
Maintenance sheet located at the end of this section.
ITEM
Drive Shaft Yoke, U-Joint
& Stub Shaft
Pump Drive Shaft Coupler
Crankshaft Adapter
Pivot Points
Hydraulic Fittings
Knives
Spindle mouting bolts
spindle to deck)
Knife mounting bolts
(knife to disk or blade bar)
Disk/Blade Bar mounting bolts Check
(disk/blade bar to spindle)
Belts
Main Frame and
Deck
Hydraulic Fluid Level
Rear Flail Drive(if applicable)
Bear Flange and Shaft Coupler
Cutter Shaft and
Ground Roller
Boom
©2011 Alamo Group Inc.
MAINTENANCE
Daily or Every 8 Hours
SERVICE
Grease
Check and Lube
Check rubber grommets
Lubricate
Check for leaks
Check
Check
Check
Check/Adjust
Check
Check
Lubricate
Lubricate
Maintenance Section 4-4
COMMENTS
Grease as instructed in
detailed maint. section
Insure drive shaft end play
Replace grommets if
damaged or missing
Inject grease until it
appears at end
Tighten when needed. Do Not use hands
to check for leaks, see maint. Precautions
Inspect for missing or damaged knives,
change as needed.
Torque to 331ft. lbs. lubricated
Torque to 357ft. lbs. dry
Pre-lubricate threads, then
torque to 800 ft. lbs.
Torque to 184ft. lbs. lubricated
Torque to 180ft. lbs. dry
Check if broken, tighten as required
Retorque bolts to torque
specifications in this section
Add if required per fluid recommendations
Grease as instructed in
detailed maint. section
Grease as instructed in
detailed maint. section