Tiger CNH T6010-80 Mounting And Operating Instructions page 69

REAR STOW AXLE BRACE MOUNTING
The axle braces are to be mounted under the rear axle of the tractor. The other end
of the axle brace mounts on the outside of the lower rear corners of the main frame. After
attaching the boom rest, it should fit tightly and level under the tractor. Attach the right
axle brace to the main frame with hardware shown in the parts section and tighten.
Attach the axle braces to the rear axle using the mounting hardware shown in the parts
section, but DO NOT tighten until the Main Frame is tightened. Tighten the hardware on
the Boomrest after the Axle Braces.
BOOM MOUNTING BRACKET
Using a floor jack and/or a hoist, raise the boom mounting bracket up to level and
slide the bracket into position onto the main frame as shown in the Parts Section.
Install the pin through main frame and bracket. Secure with capscrew and nylock nut
through the boss on the main frame.
Secure mounting bracket to the main frame with the capscrews, flatwashers, cut
flatwashers and nylock nuts provided. Secure through the two slotted holes on the
bracket and main frame.
ASSEMBLY
(ASM-C-0081)
(ASM-C-0084)
Assembly Section 2-37