Regular Maintenance - Tiger M105X/S Mounting And Operating Instructions

The intervals at which regular servicing should be done are based on hours of
operation. Use the tractors hour meter to determine when regular servicing is
required.
This symbol indicates a point that needs to be greased at an interval
noted in the section below. Refer to the Detailed Maintenance section
for further instructions on greasing. Copy and use the Daily
Maintenance sheet located at the end of this section.
ITEM
Drive Shaft Yoke, U-Joint
& Stub Shaft
Pump Drive Shaft
Crankshaft Adapter
Pivot Points
Hydraulic Fittings
Knives
Spindle mounting bolts
(spindle to deck)
Knife mounting bolts
(knife to disk)
Disk mounting bolts
(disk to spindle)
Belts
Main Frame and
Deck
Hydraulic Fluid Level
MAINTENANCE

REGULAR MAINTENANCE

DAILY OR EVERY 8 HOURS
SERVICE
Grease
Check and Lube
Check rubber grommets Replace grommets if
Lubricate
Check for leaks
Check
Check
Check
Check
Check / Adjust
Check
Check
Maintenance Section 4-3
COMMENTS
Grease as instructed in
detailed maint. section
Insure drive shaft end play
damaged or missing
Inject grease until it appears
at ends
Tighten when needed. Do Not
use hands to check for leaks,
see maintenance precautions
Inspect for missing or
damaged knives, change
or sharpen as needed
3/4" x 2" torque to 331 ft. lbs.
Pre-lubricate threads, then
torque to 800 ft.lbs
5/8" x 1-3/4" bolt to torque
204 dry or 184 oiled ft. lbs.
Check if broken, tighten
as required
Retorque bolts to torque
specifications in this section
Add if required per fluid
recommendations