Tiger CNH T6010-80 Mounting And Operating Instructions page 35

Install the pump mounting bracket on the front of the tractor with cap-screws and lock-washers
as shown in the parts section illustration. DO NOT tighten fasteners at this time.
Slide the pump drive shaft into the crankshaft adapter. The end with the shorter splines
should be inserted into the adapter (if applicable).
Slide the splined drive shaft coupler onto the pump drive shaft. Install the pump onto the
mounting bracket. NOTE: The shaft is offset to one direction, the pump should be installed with
the offset side on top. Install hardware for securing pump to the pump mount, DO NOT tighten.
Align pump so that splined coupling can be moved back and forth by hand. Tighten pump
mounting bolts in succession rechecking for spline coupling movement. Remove the pump
mounting bracket bolts one at a time and apply a tread locking agent. Tighten these bolts in
succession, again checking for free movement in the drive shaft. After all bolts are torqued, the
end play on the drive shaft should be 1/16" to 1/8", and coupler should move freely with hand
pressure. If end play is less than 1/16", grind the end of the shaft to achieve the proper end play.
If there is more than 1/4" of end play, return the shaft with specifications for a longer shaft.
CAUTION: DO NOT START THE TRACTOR UNTIL ALL HOSES ARE ATTACHED, TANK
IS FILLED WITH PROPER OIL AND BALL VALVES ARE OPEN! STARTING AT THIS TIME
WILL CAUSE SERIOUS DAMAGE TO THE PUMP.
Raise rear of tractor onto jack-stands.
manual for adjusting tires and rims to 72" center for side mounted mowers and 79.8" for boom
mowers. NOTE: This may require switching the wheels to opposite sides of tractor. Also take
note of any width restrictions when transporting by trailer. (For ease of installation, it is best to
leave the rear wheels removed during installation of the mower.)
With an overhead hoist and / or jack-stands, raise one side of the frame up to the correctly
matching mounting holes. Install capscrews and all other hardware as shown in main frame
parts section to secure the sides of the main frame to the tractor casting, DO NOT tighten at this
time. Remove the capscrews one at a time and apply a thread locking agent. Reinsert the
capscrews and tighten / torque to values noted in the torque chart located in the maintenance
section of this manual.
ASSEMBLY
FRONT PUMP MOUNTING
ADJUSTING REAR WHEELS
MAIN FRAME INSTALLATION
(ASM-C-0003)
Assembly Section 2-3
(ASM-NH-0024)
Follow the instructions in the tractor owners
(ASM-NH-0051)