Tractor Preparation - Tiger CNH T6010-80 Mounting And Operating Instructions

Before attempting to mount your Tiger mower, it is important
to read an understand all of the Safety Messages in the Safety
section of this manual.
Check complete shipment list against the packing list to make sure there are no
shortages. Make certain the tractor model is the appropriate one for the mower received!
Always use a floor jack, hoist or fork lift to lift and raise heavy parts.
Read and understand the entire assembly section instructions before attempting to mount
your Tiger mower. Refer to the parts section of this manual for detailed illustrations to locate all
parts.
(ASM-C-0001)
A. Remove right and left hand steps.
B. Disconnect battery cables from both batteries.
C. Remove engine side panels, or raise hood to access front pulley.
D. Remove plugs from tractor casting where main frame and pump mount will be attached.
E. Remove any front weights and weight supports.
F. Raise the tractor onto jack-stands and remove the right and left rear wheels.
(ASM-C-0024)
If necessary remove the four capscrews from the crankshaft pulley. Then install the crank-
shaft adapter to the pulley with capscrews and lockwashers as shown in the parts section.
(ASM-NH-0050)
ASSEMBLY

TRACTOR PREPARATION

CRANKSHAFT ADAPTER
Assembly Section 2-2