Tiger CNH T6010-80 Mounting And Operating Instructions page 51

CABLE CONTROL LEVER STAND
Place the front edge of the support bracket 2-3/4" back from the lower right front window.
Rotate stand to be 2-1/4" from the right door frame as shown below. Be sure that the location of
the stand will allow clearance between the cable control handles and all existing interior levers,
etc.
Drill 3 holes to match control bracket and secure with capscrews and nylock nuts noted in the
Parts Section.
Cut a 2-1/4" hole in the door from inside the cab. This hole is to be located 2-1/2" away from
the floor, and 4" from the metal edge by the right door. Install trim lock around the metal edges of
the then route the cables through the hole. Next, wrap the cables with the 6" split hose at the
point they pass through the hole, and secure with zip-ties.
ASSEMBLY
Assembly Section 2-19
(ASM-NH-0058)